PDE Manufactured Parts

  • Display:
  • List
  • Grid
Sort By:

1978-79 Tank Mounting Top Hat (set of 2)

Get that fuel tank sitting pretty with this tank mounting top hat set! Drilled to ...


43mm Triple Clamps - Honda CR250 (1979-80)

Specifically designed and manufactured by Phil Denton Engineering Limited to enable the fi...


Billet Alloy Exhaust Mount Set

Billet Alloy Exhaust Mount Set fits Honda CR250 1978-1980. Machined from high grade 608...


Billet Alloy Gas Cap Assembly

The perfect finishing touch to your perfect paint job! A billet alloy fuel cap! Ma...


Bottom Engine Bolt (78-79 only)

Perfect finish and a perfect fit! Machined from corrosion resistant 431 Stainless Steel...


Brake Pedal Pivot Bush Set

Stop the flop!! Replace those worn and sloppy brake pedal bushes with our new phosphe...


Chain guide assembly (alloy) Honda CR 250 1978-1980

Modern guide rubber, shock protection, race proven,unrivalled quality and dammed good look...


Chain Roller Lowering Kit

The lower chain roller area is a very busy place.  There are lots of components ...


Clutch Arm Retainer Screw

Perfect reproduction of the original Honda item. Corrosion resistant Stainless Steel. ...


Clutch cable boss, Front sprocket guard mounting bolt

This bolt is used to mount the following parts. Clutch cable boss. Front sprocket guar...


Cylinder head steady bolt

Machined from high tensile 431 Stainless Steel. Drilled and dished head to reduce weigh...


Exhaust Mounting Bolt

This bolt is for the middle exhaust mounting bracket. (to frame) Machined from cor...